Are you rocking a SMOK Nord? Have you encountered these SMOK Nord problems? Below we’ll look at the most common SMOK Nord issues and provide answers on how to fix them…
Dry Hits From Coils (The #1 Problem & The Worst To Fix)
If you know SMOK, you know that it isn’t exactly great when it comes to quality control for its coils. SMOK sub-ohm tanks have been plagued for years by sub-standard coil heads that burn out too quickly. I thought the Nord was different when I tested it;
SMOK makes dud batches of coils and ships them all over the world. Like a super-annoying Wonka Ticket, it’s something of a lottery whether you get one or not. But they’re out there, and they’re terrible. And once you install one of these dud coils, it’ll burn out within a day or two – sometimes less.
When The Coils Are Playing Ball (Which Is Most of The Time), The SMOK Nord is One of The Best Pod Vapes Around. And For The Price (Less Than $30), It Delivers Truly Exceptional Value For Money.
And the bad news is that there is no way around this issue; if you buy a pack of dud coils, as I just did, you have to ride it out and hope there is at least one good one in the package. Nine times out of ten, there isn’t. For whatever reason, when SMOK makes these dud packs of coils, whatever messes them up, affects all of them.
Using the right vape juice helps, but nothing can save you from a batch of dud coils.
For me, given how good the SMOK Nord is when it’s performing, this is the #1 most annoying issue of the pod device. If its coils were as good as the FreeMax AutoPod’s for instance, I’d happily use the Nord more or less exclusively, as I adore its design, the feel, and how it vapes. But, no, SMOK just won’t let that happen.
How To Prime SMOK Nord Coils Properly Every Time
As noted above: you can’t escape SMOK’s dud coils, but you can make sure you’re priming your coils correctly. And don’t worry, it’s super-easy. All you have to do is follow these steps:
1.Hold the coil in your hand and drop E Juice down through the hole onto the cotton.
2.Keeping dripping droplets of E Juice until the cotton you see in the wicking holes on the sides changes color.
3.Check the little wicking holes on the side of the device. Do they look wet? If they do, the coil is primed and ready to go.
Why Is My SMOK Nord Leaking?
I haven’t experienced this problem, but it is a fairly common one. It is also straightforward to fix; you need to make sure you’re not overfilling your pod. If you’ve experienced a leak with your SMOK Nord, try filling it up to about 80% of its maximum. Doing so should fix most leaking issues.
Another thing to consider: make sure you’re installing the coil heads correctly. For the best possible performance, you need to make sure the two open sides at the base of the coil are facing outwards (to the left and right of the device).
Installing the coil in this manner ensures that it wicks correctly. It also means that the coil’s cotton will not over-saturate which can lead to leaking and gurgling when you take a hit on the Nord. Paying close attention to coil positioning should help with these problems.
Can You Run Nic Salt E Juice With SMOK Nord 0.6 Coils?
Yes and no. I mean, you can run Nic Salts E Juice on the sub-ohm 0.6ohm coil head, but there are a couple of things you need to know:
·Nic Salts E Juice is for MTL vaping; running it in a sub-ohm environment, where more vapor is present, means you’re getting a massive hit – and if you’re using potent Nic Salts vape juice, this can cause nausea and head-rushes. Not good.
·Ideally, you’re better off running regular high VG E Juice with the 0.6ohm coil. You can go up to 50/50 PG/VG if you are not getting enough of a throat hit, but you’ll want to keep the nicotine down to around 12MG – any higher and the harshness will become too great, ruining your vaping.
Rule of thumb? Use Nic Salts juice with the 1.4ohm coils and regular E Juice with the 0.6ohm coil heads. I know this might seem like an obvious point, but it is something that continually trips-up new vapers when they first start using vaping products.